The reason for the slowing down of the crushing process of the vertical composite crusher

Composite crusher, also known as composite crusher, is mainly used for secondary or tertiary crushing in industries such as mineral processing, coal, building materials, chemical industry, refractory materials, metallurgy, cement, glass, ceramics, and power. If you find that the broken materials in the equipment have slowed down, please contact the after-sales personnel in a timely manner for handling. So what is the reason for the slow fragmentation process?

Firstly, the blockage of the composite crusher may be caused by too fast feeding speed. When the feeding speed is too fast, the load of the composite crusher will increase, leading to unloading or blockage due to untimely processing. In this case, we should always pay attention to the feed rate of the composite crusher and the indication of the ammeter.

Secondly, when the feeding amount is large, the indication value of the ammeter of the composite crusher is relatively high. When the rated current exceeds the equipment, it will cause overload operation. In this case, working for too long can cause the motor of the equipment to block or even burn out. When this situation occurs, on the one hand, the amount of feed should be immediately reduced and the feed equipment should be adjusted. Therefore, when selecting equipment, it is necessary to choose suitable equipment to ensure that the composite crusher can work safely and effectively during the production process.

Thirdly, after working for a period of time, the composite crusher may experience problems such as aging, crushing, meshing, and corresponding accessory crushing, or when the crushed material of the composite crusher has a high moisture content, the discharge of the equipment may slow down or even block. Problem. In this case, regular inspections, maintenance of equipment, and timely replacement of relevant components of the composite crusher should be carried out. Ensure the safe, stable, and efficient operation of the equipment. Usually, the moisture content of the crusher of the composite crusher should be controlled below 14%. After working for a period of time, equipment should be maintained and repaired.

Fourthly, the problem of slow or blocked discharge from the composite crusher is fan blockage, which may be caused by incompatible conveying equipment. When problems are discovered, the fan should be cleaned first, and then the corresponding conveying equipment should be replaced in a timely manner.